Télécharger AudioEffX sur PC

AudioEffX Sur iTunes

• Tail delay - Sets the amount of time that elapses between the direct sound and the reverberation tail.  The Delay effect provides you with two different types of delay effects using two delay lines.  The Reverb effect is used to simulate the sound reflections off walls in different kind of rooms.  The Drive effect provides you with different types of distortion from hard clipping to soft distortion simulating analog tube amplifiers and tape machines.  The delay time of both delays is modulated by one LFO with adjustable frequency.  For typical flanging effects the delay time should be below 5 milliseconds.  Seven studio quality effect modules for live usage and to enrich your iTunes music library.  The Chorus effect is a modulation effect used used to create a richer, thicker sound and add subtle movement.  • Reverb time - The time the reverb takes to die away by 60dB after the end of the initial sound.  The effect roughly simulates the slight variations in pitch and timing that occur when multiple performers sing or play the same part.  This delay time is modulated by an LFO.  Due to absorption the reverberation time is shorter for high frequencies than for low frequencies.  • Diffusion - The Diffusion parameter controls the echo density of the resulting reverberant sound.  You can select between a stereo delay and a ping-pong delay where the echoes bounces across the stereo field.  The ParaEQ effect is a parametric equalizer with optional graphic editing of Lowpass/Highpass and Bandpass equalizer stage.  The Flanger is composed of two independent delay lines with feedback for the left and the right channel respectively.  delay time.  With Sync mode the delay times can be set by note lengths and are then relative to the currently set tempo.  • Room size - The room size parameter sets the average distance between the reflecting walls.  • Apply multi effect to any song in your iTunes library.  The sound balance can be adjusted using a combined High/Lowpass filter.  • Tail stereo - Adjusts the stereo image width of the reverberation tail.  • Tail cutoff / tone - Lowpass and Highpass filter for the reverb tail.  • Absorption - The Absorption parameter simulates the surface and air absorption of high frequencies.  All effect modules can be used together chained in any order you like.  with the perceived size of the simulated room.  disperse the sound, enriching it by overlapping the sound with its reflection.  With higher absorption high frequencies will decay much faster.  with the perceived size of the simulated room.  corresponds to a higher echo density which is in most cases more natural sounding.  The delayed signal can be feed back to the input for echo effects.