Télécharger GPS Twin Odometers sur PC

GPS Twin Odometers Sur iTunes

There are tick marks to indicate the second decimal place number centered on the display as well as increments of +0.0025, +0.0050, and +0.0075. When touched, the Control button will pause the two odometers for 4 seconds to allow you time to estimate distance to thousandths.  Time, distance, and mode (discussed below) may be chosen at the start of a new rally by touching the Set button to access app Settings.  In Lap mode, the tabular display will reset the stopwatch to zero when the control button relabeled Lap Reset is touched and each split time will be identified as a Lap in the table.  In Regularity mode, the stopwatch will be reset to zero each time the Control button is pressed.  Also, in Lap mode, the options to zero either of the odometers are removed, however the lower odometer can be set to zero at the start of each lap by touching the Lap Reset button.  From time to time you may measure time and distance for a stage or a checkpoint and record data by touching the Control button.  The leftmost button activates the lower "interval distance" odometer; the rightmost button activates the upper "total distance" odometer; the center button activates both odometers.  In Jogularity mode the time split will be recorded but the stopwatch will continue recording.  Also, the displayed accuracy of two decimal places conforms to typical historic, classic, and vintage road rally restrictions.  The time and distance will be stored in a log along with geographic coordinates.  Note: Use of the GPS Twin Odometers during any particular rally will be subject to the rules and instructions governing the rally and may define your category or class among participants.  However, it is possible to interpolate distance to three decimal places.  There are three modes of operation selectable in the app Settings: Regularity mode, Jogularity mode, and Lap mode.  Historic, Classic, or Vintage road rallies may permit digital dual odometers, clocks, and stopwatches.  GPS inputs are used strictly for distance measures along the rally route.  Distance options include subtraction of distance when you travel off course.  Similarly, time measurements are limited to whole seconds or cents.  This app combines all three using timers and GPS devices built into Apple mobile devices.  A set of buttons allows you to chose the active odometer.  Please consult the Rally Master for approval of the use of this app.  Direction buttons switch between forward (+), reverse (–), and park (0).  Disclaimer: Continued use of GPS running in the background can dramatically decrease battery life.  Also, you may chose between miles or kilometers.