Télécharger Velocity Filter sur PC

         


Bonne nouvelle! Une application Windows comme Velocity Filter est disponible! Télécharger ci-dessous:

Sinon, suivez les instructions ci-dessous pour utiliser Velocity Filter sur PC:

Velocity Filter Sur iTunes

In filter mode, it adds or removes high frequency energy according to the velocity of each MIDI note, so that lower velocity notes sound softer and have less high harmonic content.  Also, if you are browsing through a collection of 1000 patches, it's much easier to apply this filter to the output than to modify each and every patch to modulate the filter cutoff with MIDI velocity.  Most synthesizers respond to velocity either by modulating the cutoff frequency of a lowpass filter or by modulating the gain.  Velocity Filter does not support GarageBand because GarageBand does not support sending MIDI messages to audio effects.  In addition to MIDI velocity, you can also control the filter using MIDI-CC or aftertouch controls.  Velocity Filter is the fastest way to make all your synthesizer patches respond to MIDI velocity in a natural and musical way.  Doing velocity response that way distorts the tone of the patch in an un-musical way, especially if it uses a resonant lowpass filter.  Instead of modulating the gain of a lowpass filter, Velocity Filter modulates the gain of a high-shelf filter.  Velocity Filter can be configured as either a MIDI-controlled filter or a MIDI-operated volume control.  Velocity filter is an audio unit plugin ONLY.  In volume control mode, it adjusts the volume according to incoming MIDI velocity.  Also, the filter takes about 1 millisecond to change from loud to soft, so if you quickly switch from loud to soft, you'll hear the filter clamping down AFTER the initial attack.  All notes go through one filter, so if you play two notes at the same time, with different velocities, it will set the filter for the loudest of the two notes.  The sound is very different, and can be applied on top of the existing filters in the synth patch without destroying the tone of the patch.  You can control the amount of boost or cut and the frequency range.  This is problematic for synth patches that have near zero attack time.  So you can control it in a variety of ways.  It runs inside of host apps such as AUM, Audiobus, Cubasis, Auria, and Beatmaker 3.  It converts non-velocity-sensitive synths sounds into velocity-sensitive ones.  However, it's not necessarily "better"; it's just very different.  Read the limitations section below for why it's not always better.